afx light DC-54DMX Manuel D'utilisation page 6

When you select the program you can choose the projector which wants to attribute the scene (from 1-9). Press button "B".
The display of "PROJ." will indicate a blinking dot. Then select the number with the buttons "UP" or "DOWN."
When the projector is selected, you can adjust the values of the different sliders to program the scene which you want to
record.
When the scene finishes, click on "INSERT" button, the scene is recorded. The display "SCENES" increases to "01".
If you want to edit a recorded scene, select the programming mode. Press the "INSERT" button to activate the selection and
select a scene you want to replace with the buttons "UP" and "Down." Then press "INSERT" button again to add this new
scene. Delete the old selected one by pressing the button of "DELETE" twice.
Press the "A" button for 3 seconds to exit programming mode.
4 - Complete erasure of a program
To delete an entire program (all the scenes in it), select the programming mode (press 3 seconds on the button "A").
Then select the program with the buttons "UP" or "DOWN".
Then press the "DELETE", the message "AL" will blink in "SCENES".
Click again on "DELETE" to delete all scenes.
Press the "A" button for 3 seconds to exit programming mode.
5 - Implementation of a program
To run a program, press the "A" button. Use the "UP" or 'DOWN' to select the desired program.
The program runs automatically and cyclically from the first to the last scene.
© Copyright LOTRONIC 2016 DC54DMX Page 6