afx light DC-54DMX Manuel D'utilisation page 3

2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of the slave light. Connect
the DIGITAL OUT socket of the master and the IN socket of the slave light, then, connect the OUT socket to the IN socket of
the next light. Ordinal to connect all the lights as below:
1 2
I N
O U T
The connection between the output of master and input of product, it's available to use the 3 pins XLR.
Signal cable from the DMX output of the controller to the input of the first master light, and connect to the DMX input of
second slave light from the DMX output of the first master light, analogously, till connected all the slave lights, and insert the
last connector to the output of the final light. (Notice: the diameter of core of every cable should be 0.5mm at least, double
core shelter cable should be used).The signal connecting must use the attached 3 pins XLR cable. Notice, all the internal lead
wire of the 3 pins XLR cable should not touch to each other or connect to the connector.
A DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a 120Ω
resistor between the pin 2 and pin 3 of the XLR connector
DESCRIPTION
(1) Control Buttons :
(2) Slider Control :
(3) Viewing Scene :
(4) Viewing Program:
(5) Display projector : PROJ.
(6) Connection DMX Input: INPUT, XLR 3 Pin Female
(7) Connection DMX Output:
(8) Connection Power Supply:
(9) Power Selector:
(10) Battery Hatch:
© Copyright LOTRONIC 2016
3
I N
O U T
INSERT, DELETE, AB, UP, DOWN, SELECT
1, 2, 3, 4, 5, 6
SCENES
PROG.
OUTPUT, XLR 3 Pin Male
9V DC
Battery / External
Battery 9V 6LR61
I N
O U T
DC54DMX Page 3