INSTRUCTIONS FOR FITTING THE FILTERS AND CLOSING THE PURIFIER
1.
Place and center the absolute filter in its right position, and tighten all 4 locks
to the maximum
2.
Place the flap of the GRSystem filter below the side guides, slide it along the
guides fully and lower by 2 cm
3.
Slide the prefilter fully along the lower guides
4.
Place the metal panel in the correct position with the label containing the
serial number of the unit at the top. Then tighten the 6 screws that will seal the
unit
5.
Position the white outer panel around 5 cm from the bottom of the purifier,
and then press it towards the appliance until it adjusts, lowering them 5 cm
until it is in place
Please, contact Eurofred or your local distributor for replacements.
IMPORTANT: It is important that only original filters supplied by Zonair3D
Eurofred are used to ensure the desired result and correct operation of the unit.
The use of filters not supplied by the manufacturer will render the warranty null
and void.
MANAGEMENT OF USED FILTERS
The filters from this purifier must be taken to your local green point to be disposed
of correctly, so that they can be managed sustainably and do not create problems
for the environment.
DISPOSAL OF OLD ELECTRICAL APPLIANCES
European directive 2012/19/UE on Waste Electrical Equipment (WEEE), specifies
that old household electrical appliances must not be disposed of with the normal
unsorted municipal waste.
The crossed out "wheeled bin" symbol reminds you of your obligation to
dispose of the appliance correctly.
Consumers must contact their local authorities or retailer for information
concerning the correct disposal of old appliances and/or their batteries.
/
TM
Pure Airbox Home "S"
25