Accessories - Kenmore 106.5002 Guide D'utilisation

ICE AND WATER Possible Causes and/or Recommended Solutions
Water dispenser
■
will not operate
properly
■
■
■
■
■
■
■
NOTE: If questions remain regarding water pressure, contact a licensed, qualified plumber.
Water is leaking or NOTE: After dispensing, a few additional drops of water are normal.
dripping from the
■
dispenser
■
■
Water is leaking
■
from the back of the
refrigerator
Water from the NOTE: Water from the dispenser is chilled to 50°F (10°C).
dispenser is
■
not cool enough
■
(on some models)
■
■
Replacement Parts:
To order stainless steel cleaner or replacement filters, call
1­800­4­MY­HOME and ask for the appropriate part number
®
listed below or contact your authorized Kenmore dealer.
Doors not closed completely - Make sure both doors are firmly closed. (On some models, only the
freezer door must be closed in order to operate the dispenser.)
Refrigerator is not connected to a water supply, or the water supply shutoff valve is not
turned on ­ Connect the refrigerator to a water supply and make sure the water shutoff valve is
fully open.
Kink in the water source line - A kink in the water line can reduce water flow to the dispenser.
Straighten the water line.
Water pressure to the home is not at or above 30 psi (207 kPa) - The water pressure to the home
affects the flow from the dispenser. See "Water Supply Requirements."
New installation - After connecting the refrigerator to a water source, flush the water system.
See "Water and Ice Dispensers."
Dispenser is locked - Unlock the dispenser. See "Water and Ice Dispensers."
Water filter is clogged or incorrectly installed - Replace filter or reinstall it correctly. See "Water
Filtration System."
A reverse osmosis water filtration system is connected to your cold water supply ­ This can decrease
water pressure. See "Water Supply Requirements."
Glass was not held under the dispenser long enough - Hold the glass under the dispenser for
2 to 3 seconds after releasing the dispenser pad/lever.
New installation, or water filter was recently installed or replaced - Air in the water lines causes the
water dispenser to drip. Flush the water system to remove the air in the water lines. See "Water and
Ice Dispensers."
Residual ice in the dispenser chute is melting - Make sure the ice chute is free of ice shavings or pieces.
Water line connections are not fully tightened - Make sure all connections are firmly tightened. See
"Connect Water Supply."
New installation - Allow 24 hours after installation for the water supply to cool completely.
Recently dispensed a large amount of water - Allow 24 hours for the new water supply to cool
completely.
Water has not been recently dispensed - The first glass of water may not be cool. Discard the first
glass of water dispensed.
Refrigerator is not connected to a cold water pipe - Make sure the refrigerator is connected to a cold
water pipe. See "Water Supply Requirements."

ACCESSORIES

Stainless Steel Cleaner and Polish:
Order Part #D22 M40083 R
Water Filter:
Order Part #9930 (P4RFKB2 or P4RFKB12)
27