Adjustment; Water And Ice Dispensers - Kenmore 106.5002 Guide D'utilisation

If you need to adjust temperatures in the refrigerator or freezer,
use the settings listed in the chart below as a guide. Wait at
least 24 hours between adjustments.
CONDITION/REASON:
REFRIGERATOR too warm
FREEZER too warm/
too little ice
REFRIGERATOR too cold
FREEZER too cold

Water and Ice Dispensers

Depending on your model, you may have one or more of the
following options: the ability to select either crushed or cubed
ice, a special light that turns on when you use the dispenser, or
a lock option to avoid unintentional dispensing.
NOTES:
The dispensing system will not operate when either door
■
(refrigerator or freezer) is open.
Allow 24 hours for the refrigerator to cool down and chill
■
water.
Allow 24 hours to produce the first batch of ice. Discard the
■
first three batches of ice produced. Wait 72 hours for full
ice production. Also, take large amounts of ice from the ice
bin, not through the dispenser.
Flush the Water System
Air in the water dispensing system can cause the water
dispenser to drip. After connecting the refrigerator to a water
source or replacing the water filter, flush the water system.
Flushing the water dispensing system forces air from the water
line and filter, and prepares the water filter for use.
NOTE: As air is cleared from the system, water may spurt out
of the dispenser.
1. Using a sturdy container, depress and hold the water
dispenser lever for 5 seconds, and then release it for
5 seconds.
2. Repeat Step 1 until water begins to flow.
3. Once water begins to flow, continue depressing and
releasing the dispenser lever (5 seconds on, 5 seconds off)
until a total of 3 gal. (12 L) has been dispensed.
Additional flushing may be required in some households.
14

ADJUSTMENT:

REFRIGERATOR Control
one setting higher
FREEZER Control
one setting higher
REFRIGERATOR Control
one setting lower
FREEZER Control
one setting lower
The Water Dispenser
IMPORTANT:
Dispense at least 1 qt (1 L) of water every week to maintain
■
a fresh supply.
If the flow of water from the dispenser decreases, it could be
■
caused by low water pressure.
With the water filter removed, dispense 1 cup (237 mL)
■
of water. If 1 cup of water is dispensed in 8 seconds or
less, the water pressure to the refrigerator meets the
minimum requirement.
If it takes longer than 8 seconds to dispense 1 cup of
■
water, the water pressure to the refrigerator is lower than
recommended. See "Water Supply Requirements" or
"Problem Solver" for suggestions.
To Dispense Water:
1. Press the WATER button to select water.
2. Press a sturdy glass against the dispenser lever. Hold the
glass close to the water dispenser spout to ensure that the
water dispenses into the glass.
A. Water dispenser spout
3. Remove the glass to stop dispensing.
IMPORTANT: The small tray at the bottom of the dispenser is
designed to catch small spills and allow for easy cleaning. There
is no drain in the tray. To empty and clean the tray, push down
on the back of the removable tray lid and pull it out.
Style 1:
Style 2:
A