Power Switch - YORKVILLE 50KW POWER WEDGE Manuel De L'utilisateur

Effects Loop
The EFFECTS LOOP can be used to insert signals from external sources such as a Digital
Effects Unit or Equalizer into the signal path. The loop is inserted after the tone and vol-
ume controls. To use the EFFECTS LOOP connect the EFX SEND jack to the input of the
equalizer or effects unit. Connect the output of the equalizer or effects unit to the EFX
RTN jack to complete the loop.
Linking Together Multiple Wedges
When the Yorkville 50kb/kw is used with a line level input for stage monitor purposes,
it's possible to link together several units by using the inputs on Channel 2. Insert the
mixed signal from a mixing console into either of the two phone jacks (on Channel 2).
It is possible to use the remaining phone jack input on Channel 2 as an output to link to
another Yorkville 50kb/kw.
Phones
Headphones can be connected to the Yorkville 50kb/kw by inserting a headphone plug
into the PHONES jack located on the front panel. While headphones are connected,
the internal speaker is disconnected. Always use stereo headphones. The audio heard
through stereo headphones will be a mono signal separated into the two earpieces.

Power Switch

When the Yorkville 50kb/kw is turned on, the LED beside the power switch will
be illuminated.
2
Please note: that only information being sent to the input of Channel 2 will be linked.
Caution: Always exercise caution when using headphones to avoid permanent hearing loss.
Power @ min. impedance (Watts)
Minimum Impedance (ohms)
Speaker Configuration - LF (Size / Power)
Speaker Configuration - HF (Size / Power)
Line Out (type / configuration)
Line Out Sensitivity (Vrms)
Effects Loop / Location
Effects Return Sensitivity (Vrms)
Dimensions (DWH, inches)
Dimensions (DWH, cm)
Specifications
50
4
70 Watts
Burst Power - 2 cycle
10 inch / 50 Watts
3.75 inch / 75 Watts
2
Input Channels
XLR, 1/4 inch TRS
Channel 1 - inputs
Volume
Channel 1 - controls
2x 1/4 inch TRS, RCA
Channel 2 - inputs
Volume
Channel 2 - controls
Low, High
Main Tone Controls
ch. 1 XLR=3 Phone=10, ch.2 Phone=100 RCA=100
Input Sensitivity (mV)
1/4 inch / Front (Effects Send)
1
Yes / Front
1
Power
LED Indicators
No
Limiter / Switchable
Yes
Headphone Jack
50KB: 12 x 15 x 17; 50KW 17 x 15 x 17
50KB: 30 x 38 x 43; 50KW 43 x 38 x 43
50KB: 22.5 / 10.3; 50KW 24 / 11
Weight (lbs / kg)