JVC KD-LX50 Manuel D'instructions page 29

9
Speak the same word(s) again while "REPEAT" is flashing on
the display. (In this example, speak "Turn off.")
If the recording fails
A beep sound comes out and the display goes back to the one shown in step 6.
10
Repeat steps 6 to 9 to record your own voice for other preset
Operation Commands (VOICE 02 to VOICE 13).
11
To make the system recognize and accept the preset voice
commands anyone speaks
Set "VOICE WORD" to "STANDARD" by following steps 1 to 4 on page 27. (In step 3, press +
to select "STANDARD.")
To erase your own voice from the Operation Commands
See "To erase the voice commands" on page 37.
"CHECK" appears on the display while recording your voice.
"OK" appears when
recording is complete.
" " on the display means that your own voice is recorded for this voice
command.
Press and hold VOICE again to finish the recording.
STOP
PLAY
29