UP-TOUCH POWER UNIT INSTALLATION FOR CB-Touch control
» Purpose
WE RECOMMEND THAT YOU READ THESE
INSTRUCTIONS CAREFULLY BEFORE USING THE
CONTROL.
The CB-Touch control allows to control and adjust the
room temperature in a simple and intuitive way by
means of a probe positioned in the lower part of the
device.
CB-Touch allows you to select the desired operation
mode, heat, cool or just ventilate the room, set a
desired temperature set and adjust the fan operating
speed according to your needs.
You will choose the maximum operating speed when
you want to quickly reach the comfort temperature
» Assembly of the power unit
Instructions for installing the power unit when not factory installed.
The basic units, supplied without controls, are equipped with an electrical terminal board prepared for
connection to external controllers.
To install the power unit proceed as follows:
1. It is necessary to remove the cable fastener (1)
and the terminal board group with the related motor
cables (2) from the right side of the fan coil unit.
1
2
or the minimum speed when you want to privilege
silent operation.
By connecting the minimum probe (T3 accessory
probe, located between the fins of the heat exchange
coil), during the winter cycle, the fan will only start
operating if the water temperature is above 30 °C, thus
preventing cold air from flowing out from the device.
To improve comfort, it is also possible to select the
night mode which minimises the fan speed and
smartly changes the set temperature independently.
The control is designed to be operated remotely
through the smart features of your mobile phone
using the wireless Bluetooth® or Wi-Fi connection via
an APP downloadable from the web.
Always disconnect the electrical
power supply before opening the unit.
2. Remove the terminal board applied on the
shoulder by unscrewing the two self-tapping screws.
The two holes shown in the figure are those that will
then be used to fix the power board.
29
English