Fault Indicator, Rotary Switch Control - Salvis Compactline Série Mode D'emploi

en
7.2

Fault indicator, rotary switch control

These faults can be rectified only by an authorised customer service technician.
Error message display
‒ The indicator lamp lights up once for approx. 0.6 seconds and twice for approx. 0.3 seconds.
‒ This is followed by rapid flashing signals.
Example error no. 5 - number of flashing signals
long
The flashes must be counted. The number of flashes indicates the error code. The error can be de­
termined from the table below.
Number of
flashes
2
3
5
6
10
14
20
00
30 / 64
short 1 2 3
Fault
System integrity
Dual side control lost
Bus not connected, no
communication
Bus collision
Line breakage
Supply voltage to ro­
tary switch control is
faulty
Local Interconnect Net­
work (LIN) compatibility
Unknown error
4 5 long short
Cause
Defective rotary switch
control
Bus node for dual side
control is damaged, bus
connection is faulty
Bus connection faulty,
bus connecting cable de­
fective
Connection conflict, ad­
dress ID conflict
Connection between ro­
tary switch control and
generator is faulty or de­
fective
Cable connection is
faulty or rotary switch
control is defective
LIN version is not com­
patible
Unknown error
1 2 3 4 5
Action
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.
This fault must be rectified by
an authorised customer ser­
vice technician.