D-Link NetDefend DFL-260E Guide D'installation page 6

To establish a console connection:
1. Plug the female end of the supplied RJ-45-
to-DB9 cable directly to the console port on
the Firewall, and tighten the captive retaining
screws.
2. Connect the other end of the cable to
a terminal or to the serial connector of
a computer running terminal emulation
software. Use the following settings for
terminal emulation software:
Baud rate: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
3. Once you have correctly set up the terminal,
switch on your device. A boot sequence will
appear on the terminal screen.
4. Once the boot sequence completes, the
command prompt is displayed, the device is
ready to be configured.
Finalizing the Configuration
After initial setup, please refer to the companion
publications found in PDF format on the accom-
panying master CD for detailed instructions on
configuring the DFL-260E/860E.
D-Link NetDefend Firewall User Manual
This document describes the general operation
and control of the NetDefendOS firmware,
D-Link's proprietary operating system that drives
and controls the NetDefend firewall.
The User Manual includes detailed instructions
regarding typical administrative tasks.
D-Link NetDefend Firewall Log Reference
Guide
This document describes all log messages that
might be generated by the NetDefendOS.
D-Link NetDefend Firewall CLI Reference
Guide
This document describes all available text-
based commands that can be used with the
RJ-45-to-DB9 Console or SSH interface to
configure the firewall.
Additional Information
In addition to the user manual, the Master
CD also includes many device configuration
examples. Additional help is available through
D-Link worldwide offices listed in the appendix
of the User Manual or online. To learn more
about D-Link security product products, please
visit the website http://security.dlink.com.tw. For
support, please visit the website http://support.
dlink.com.tw, which will redirect you to your
regional D-Link website.
TECHNICAL SUPPORT
United Kingdom (Mon-Fri) website: http://
www.dlink.co.uk FTP: ftp://ftp.dlink.co.uk
Home Wireless/Broadband 0871 873 3000
(9.00am–06.00pm, Sat 10.00am-02.00pm)
Managed, Smart, & Wireless Switches, or
Firewalls 0871 873 0909 (09.00am- 05.30pm)
(BT 10ppm, other carriers may vary.)
Ireland (Mon-Fri)
All Products 1890 886 899 (09.00am-06.00pm,
Sat 10.00am-02.00pm)
Phone rates: €0.05ppm peak, €0.045ppm off
peak times
6