Drip Stop Function - Micromaxx MD 15486 Mode D'emploi

7.2.2. Brewing process using coffee powder
 Add the corresponding amount of coffee powder to the filter. The recommend-
ed amount is 1 heaped teaspoon per cup.
 Close the filter holder again.
 Set the desired number of cups (2, 4, 6, 8, 10 or 12 cups) by repeatedly pressing
the CUPS button. If you do not set the number of cups, the largest number of
cups (12 cups) will be used for the brewing process.
 Press the STRENGTH button repeatedly to adjust the strength of the coffee
based on the amount of water used:
Stronger coffee (less water)
Medium strength coffee (normal amount of water)
Weaker coffee (more water)
 Ensure that the grinder is switched off (GRINDER LED is lit). If necessary, press
the GRINDER button so that the Grinder LED lights up.
 Press the PAUSE/START button to start the brewing process. BREW appears
on the display and the brewing process will start.
Once the brewing process has ended, BREW will disappear from the display and a
signal tone will sound.

7.2.3. Drip stop function

The drip stop function enables you to serve the already finished coffee while the
brewing process is still in progress.
 Carefully remove the glass jug from the warming plate. The flow of coffee from
the filter to the jug will be interrupted; the coffee will now accumulate in the fil-
ter.
 Place the glass jug under the filter again within 30 seconds. Otherwise there is a
risk that the filter will overflow.
The strength of the coffee that is taken in the middle of the brewing process may
differ from the strength of the coffee after the complete brewing process.
30 of 118