Princess SUP 025PY Mode D'emploi page 31

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 54
10.1
The coffee disperser
The coffee dispenser (17) must be cleaned
each time you fi ll the coffee bean container
or, anyhow, at least once a week.
• Switch off the appliance by pressing the ON/OFF
switch (7) to the "O" position and remove the plug
from the wall outlet.
• Open the service cover (15). Remove the drip tray
(12) and the coffee grounds drawer.
• Remove the coffee dispenser, holding it by its handle
and pressing the "PUSH" button (Fig.22)
• Wash the coffee dispenser only with hot water: do
not use detergents.
• Carefully wash the top fi lter (Fig. 23) and make sure
it is free from any coffee residues. Then, thoroughly
dry all its components.
• Carefully clean the compartment inside the applian-
ce.
• Holding it by its handle, insert the coffee dispenser
into its housing until it snaps into place.
• Insert the coffee grounds drawer, the drip tray plate
and the drip tray.
• Close the cover (15).
11 DESCALING
Scaling occurs naturally when the appliance is used.
Approximately every 3-4 months you should descale
it; it is ready for descaling when you notice a reduction
in the water fl ow or when the LED of the button (26)
fl ashes.
If you wish to carry this out at home, you can
use a descaling product for coffee makers
that is non toxic and/or not harmful and commonly
available on the market.
Caution! Never use vinegar.
To descale the appliance proceed as follows:
• Mix the descaler with water as specifi ed on the
package and fi ll the water tank.
• Switch ON the appliance with the ON/OFF switch
(7).
• Press the button (26) for at least 5 seconds to select
the descaling operating mode; the LED emits a fi xed
light.
• Direct the steam nozzle (14) toward the drip tray.
• Position a vessel of adequate capacity under the
steam nozzle and turn the hot water knob anti-
clockwise (16). The appliance starts an automatic
descaling cycle with pauses preset by the manufac-
turer and managed automatically by the appliance.
• At the end of the cycle, the fl ow of the descaling
solution is shut off and the 5 buttons start fl ashing
simultaneously.
• Turn the knob of the hot water nozzle (16) clockwise
to OFF. In this case, also the warning light (27)
fl ashes.
• Rinse the water tank and fi ll it with fresh drinking
water.
• Position a vessel of adequate capacity under the
steam nozzle and empty 2/3 of the contents of
the water tank by turning the steam knob (16) an-
ticlockwise; to shut off the fl ow, turn the knob (16)
clockwise.
• Let the appliance heat up and empty the remaining
contents of the water tank by turning the steam
knob (16) anticlockwise; to stop the fl ow, turn it
clockwise.
If you use a different product from the re-
commended one, we recommend you follow
the instructions of the descaler manufacturer as
specifi ed on the package.
If the descaling cycle is interrupted by
switching the machine OFF, this is restarted
when the machine is switched back ON.
• 31 •
ENGLISH

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

242154

Table des Matières