Adjusting The Coffee Dose; Making Coffee With Coffee Beans - Princess SUP 025PY Mode D'emploi

ENGLISH
5 THE COFFEE GRINDER (FIG.10)
Caution! Only turn the grinding control
knob, found inside the coffee bean container
(Fig.10), when the coffee grinder is working. Do not
insert ground and/or instant coffee in the coffee
bean container.
Do not insert anything other than coffee beans in
the container. The coffee grinder contains dan-
gerous moving parts; keep fi ngers and/or other
objects away. Before carrying out any operations
in the coffee bean container, switch OFF the ON/
OFF switch (7) and remove the plug from the wall
outlet. Do not insert coffee beans when the coffee
grinder is working.
The quality and the taste of your coffee depend,
in addition to the used blend, also on the grinding
coarseness.
The appliance comes with a grinding adjusting knob
(Fig.10). To use this feature, turn the graduated knob
when the coffee grinder is working; the numbers
displayed on the knob indicate the grinding coarse-
ness.
The manufacturer sets the knob to an average grinding
coarseness in the factory: if the ground coffee is too
fi ne, turn the knob toward the higher values; if the
ground coffee is too coarse, turn the knob toward the
lower values.
You will note the change only after pouring
three /four coffees.
Use coffee beans for espresso coffee makers. Avoid
using limit grinding positions (e.g. 1 and 16); if this is
necessary, try using different coffee blends.
Store the coffee in a cool and dry place, in an airtight
container.
You should change the grinding position if the coffee
does not outfl ow optimally, specifi cally:
Too fast = grinding too coarse > grind coffee fi ner;
Too slow (drips and/or no fl ow) = grinding too fi ne >
grind coffee coarser.
6

ADJUSTING THE COFFEE DOSE

(FIG.11)
You may select the quantity of coffee (dose) that you
wish to grind. The manufacturer sets an average dose
in the factory.
To change the ground coffee dose, simply turn the
knob (Fig.11) found inside the coffee container. Turn
it anticlockwise to increase the dose and clockwise to
decrease the dose.
You must adjust the dose before pressing the coffee
dispenser button.
This system allows you to obtain an optimal cup of
coffee with all types of marketed coffee.
7 THE COFFEE DISPENSER
Note: If the appliance does not dispense
coffee, check the water level in the tank.
• Before making coffee, make sure that the green
temperature-ready LEDs (23) and (24) are lit and
emit a fi xed light and that the water tank and the
coffee container are full.
• Place 1 or 2 coffee cups under the coffee
dispenser spouts; you can adjust the height of
the dispenser by moving it up or down manually
(Fig.12) until it suits your cups.

7.1 Making coffee with coffee beans

• To dispense the coffee, press the correct coffee
button (23) or (24). The selected button starts
fl ashing (see chap.15), while the other switches
off.
To make 1 coffee, position a single coffee cup under
the coffee dispenser spouts and press the button
(23) or (24) only once; to make 2 coffees, position
two coffee cups under the spouts and press the
button (23) or (24) twice.
In this operating mode, the appliance automati-
cally grinds and doses the right quantity of coffee;
making two coffees requires two grinding and di-
spensing cycles, which are automatically managed
by the machine.
• Then, the dispensing cycle starts.
• 28 •