Microphone Sensitivity - AUDIOropa xepton T-1 Mode D'emploi

3.6 Microphone sensitivity

The microphone sensitivity can be adjusted through 5 levels according to en-
vironmental requirements:
On the powered-up device, press and hold the MODE-button for 3 seconds.
The symbol »GRP« in the display will blink.
Press the MODE button three times. The »C1« symbol in the display blinks. By
using the and -buttons, select between C1 (low sensitivity) and C5 (high
sensitivity).
Please note: The default setting is C3.
3.7 Audio output high / low
Apart from the volume control, it is possible to adjust the basic audio output
level. A higher audio output will raise the maximum volume – this might be re-
quired in noisy surroundings.
On the powered-up device, press and hold the MODE-button for 3 seconds.
The symbol »GRP« in the display will blink.
Press the MODE button four times. The »UH« symbol is shown in the display.
By using the and -buttons, select UH (high output) or UL (normal output).
After the selection, wait for 3 seconds to set the selected output level.
Please note:
Selecting »UH« can cause white noise and should only be used in loud envi-
ronments. We recommend the default setting »UL«.
English 16
BA Xepton T-1.indd 16 11.11.2016 08:49:22