How To Use; Group Selection - AUDIOropa xepton T-1 Mode D'emploi

3. How to use

3.1 Power ON / OFF
Use the ON/OFF switch to switch the device on. The illuminated LC display
indicates the default volume setting „VOL 03".
Use the ON/OFF switch again to switch the device off.

3.2 Group selection

Switch the device on and press the MODE-button for 3 seconds.
The symbol »GRP« in the display will blink. Select a group number of your choice
between »00« and »39« by pressing the and -buttons. After the selection,
wait for 3 seconds to set the selected group number.
Transmitters and receivers must be set to the same group number if they are to
communicate with each other.
3.3 ID selection
Within a group, each TRX-1 needs to have a different ID from »00« to »99«.
Every group must have a TRX-1 set to the master-ID »00«, which defines it as
the master transmitter of the group. In this case, »MASTER« and »TALK« are
indicated on the display. To set the ID, continue as follows:
On the powered-up device, press and hold the MODE-button for 3 seconds.
The symbol »GRP« on the display will blink.
English 14
BA Xepton T-1.indd 14 11.11.2016 08:49:20