Volume Up / Down - AUDIOropa xepton T-1 Mode D'emploi

Press the MODE-button again. The symbol »ID« will start to blink. By using the
and -buttons, select an ID from 00 to 99, while taking care that each de-
vice within the group has its own number. After the selection, wait for 3 seconds
to set the selected ID number.

3.4 Volume up / down

The volume can be adjusted through 9 levels. On the powered-up device,
press the and -buttons to adjust the volume between 01 (low) and 09
(high) as desired.
3.5 Monitoring function On / Off
The monitoring function enables you to hear your own voice over the system.
Proceed as follows if you wish to activate the monitoring function:
On the powered-up device, press and hold the MODE-button for 3 seconds.
The symbol »GRP« in the display will blink.
Press the MODE button two times. The »SO« symbol in the display blinks. By
using the and -buttons, select »SO« to activate the monitoring function
or SF to deactivate it. After the selection, wait for 3 seconds to set the selected
function.
Please note:
The default setting is »SF« (monitoring deactivated).
English 15
BA Xepton T-1.indd 15 11.11.2016 08:49:21