Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Heater Shield
Platen (may require
a new platen)
Press Arm
20150901 47314-INSTR
V. 4.0 F
page 5 of 5
Oct.2015
Manual Y151 V. 4.0 FR EUR from original TPC 47117-MAN Rev 1214
ADJUSTING THE POSITION OF THE PRESS ARM SWITCH.
•
THE SWITCH POSITION WILL BE ADJUSTED BY MOVING
THE SWITCH USING THE UPPER SLOTTED HOLES ON
THE BRACKET WHILE THE SWITCH LEVER IS MAKING
CONTACT WITH THE PRESS ARM. THE ADJUSTMENT
PROCEDURE WILL REQUIRE THE USER TO ADJUST THE
POSITION OF THE SWITCH WHILE HOLDING THE PRESS
ARM IN ITS UPWARD POSTION.
• INSTALL THE POWER PLUG INTO WALL SOCKET.
TURN-ON THE POWER TO THE MACHINE.
•
POSITION THE PRESS ARM SWITCH SO THAT THE
SWITCH LEVER ACTIVATES (CLICKS) WHILE MAKING
CONTACT WITH THE PRESS ARM WHEN THE PRESS ARM
IS IN THE UPWARD POSITION.
•
[MOVE THE PRESS ARM TO THE UPWARD POSITION SO
THAT THE PLATEN IS APPROXIMATELY 4.16 MM (0.164
INCHES) FROM THE HEATER SHIELD IN AS SHOWN IN
FIGURE-6.]
59
59
4,16 mm
Publicité
Chapitres
Table des Matières
