Perel CCTVSET10 Notice D'emploi page 11

2) Click MODIFY DATE AND TIME. Click SURE in the confirmation window.
3) Click APPLY. The new date and time are saved.
Daylight Savings Time
To set daylight savings time:
1) Under DST, select ON. DST options appear.
2) Under DST MODE select one of the following:
o CUSTOM: Set customized start and end times for DST (go to step 4)
o DEFAULT: The Default setting will apply DST from the second Sunday of March to the
second Sunday in November (go to step 3)
3) If using the DEFAULT, click APPLY.
4) If setting a CUSTOM DST, use the drop-down menus to select a week and month for the start
and end times.
5) Click APPLY. Click SURE in the confirmation window.
6) Click EXIT in each menu until all windows are closed.
7.3.4.3 PASSWORD
When you first start up your system, you are technically logged in as the ADMIN under Device
ID000000. The system allows two user authorities connected to a Device ID. The authorities are as
follows:
o ADMIN—administrator: has full control of the system, and can change both administrator and user
passwords and enable/disable password checking
o USER—normal user: only has access to live viewing, search, playback, and other limited
authorities.
For security reasons, it is highly recommended to enable passwords on your system. If you enable
passwords, you must select a 6-digit USER password and a 6-digit ADMIN password.
ATTENTION:
By default, passwords are disabled on the system. You will not need a password to log in or access
menus. You will not need a password to access your system using the browser-based remote
software.
You can change the Device ID and password of the ADMIN and the USER from the Password menu.
To open the Password/security menu:
1) Right-click anywhere onscreen to open the Sub-Menu and select MAIN MENU.
2) Click BASIC. The Basic Setup Menu opens.
3) Click PASSWORD. The Password/Security menu opens.
To change your Device ID and Password:
1) Click the field beside DEVICE ID and enter a 6-digit numerical Device ID using the Virtual
Keyboard (mouse only). For example, change the ID to 000010.
2) Under PASSWORD, select ENABLE.
3) Click the field beside USER PASSWORD to enter a 6-digit numerical password using the
Virtual Keyboard (mouse only). Re-enter the password in the corresponding field.
4) Click the field beside ADMIN PASSWORD to enter a 6-digit numerical password using the
Virtual Keyboard (mouse only). Re-enter the password in the corresponding field.
NOTE: The USER and ADMIN passwords must not be the same.
5) Click APPLY to save your changes. Click SURE in the confirmation window.
6) Click EXIT in each menu until all windows are closed.
Use your new password to log in to the system and access system menus. You can also use the USER
and ADMIN passwords to access your system using the browser-based remote software.
NETWORK PW CLEAN: select and click APPLY will initialize the IE browser password.
26/05/2011
CCTVSET10
11
©Velleman nv