Télécharger Imprimer la page

Gb Starting Locomotive Operation; Maintenance Of The Model - Roco 51313 Mode D'emploi

Publicité

Les langues disponibles

Les langues disponibles

GB
Starting locomotive operation
Unwrap model: Take the loco carefully out of
the packing with the help of the foil (fig. 1).
Operating instructions: Before use is advisab-
le to let the loco go around about 30 minutes for-
wards an 30 minutes backwards without load, to
obtain an optomal circuit and best tractive power.
The smallest radius this model should run is R3
(419,6 mm) or rather R2 (358 mm) of the ROCO
track system (model without tubes protection pis-
tons would run only if driven very carefully on R2)
(fig. 2).
14
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 46400, ROCO track cleaning van, or item
no. 10002, ROCO track cleaning rubber, for
removing heavy dirt.
Fittings: Operation is possible with different
couplings (fig. 3). We recommend using the ROCO
close coupling.
GB

Maintenance of the model

To enjoy your model for a long time, it is necesary
to service it regulary (i.e. after it has been in ope-
ration for approximately 30 hours).
1. Cleaning of wheel contacts: Wheel cont-
acts easily get dirty on tracks which are not enti-
rely clean. Use a small brush to remove dirt from
spots marked in fig. 11.
2. Lubrication: Apply tiny oil drops to spots
marked in fig. 9+10. Prior to lubrication dismantle
the loco body or the tender body (fig. 4, fig. 5).
We recommend using item no. 10906, Roco oi-
ler. For lubrication the gearparts (e.g. cogwheels,
worm) we would recommended our Roco special
grease (item no. 10905).
Attention: Please do not oil these parts when
using our grease.
3. Change of lights: First remove loco body and
the tender body (fig. 4, fig. 5) and then change
lights (fig. 6, fig. 7).
4. Change of traction tyre: The change of
traction tires requires fine mechanical knowled-
ge. Please contact your Roco dealer or a specialist
workshop.
6. Motor Changing: First remove tender body
(fig. 5), and then the motor (fig. 8).
Assembly: During assembly please take care of
correct position of contacts (fig. 8).
The red / black markings on the motor indicate the
correct position.
3

Publicité

loading

Ce manuel est également adapté pour:

18.6 série