General Safety Regulations; Personal Safety - Holmatro HCT5111 Mode D'emploi

2.2 Model plate and CE marking on the equipment (Fig. 1)
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
WARNING
Not following these instructions can result in serious personal injury, fatal accident, damage
to the system or consequential loss.
/i
Type of mark Position
Instruction A
Instruction B
Warning C
Model plate D
If the pictograms are illegible, have the protective sleeve replaced by the Holmatro dealer.
2.3

General safety regulations

• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
• Protect equipment against sparks during welding or grinding activities.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4

Personal safety

Rescue personnel must wear all personal means of protection as prescribed in the standard work
procedure. Negligent use of personal means of protection can result in serious injury. During use wear
at least the following personal means of protection:
• Helmet;
• Safety goggles or full face shield;
• Safety gloves;
• Safety clothing for the entire body with reflective material;
• Safety shoes with good ankle support and toe protection;
• Mask with filter for use when cutting glass or certain plastics.
2.5 Safety regulations with respect to the equipment
• Never change the setting of any safety device.
• Store the cutter with the blade tips over each other to prevent injury.
HCT5111 (RH)(ST)/HCT5117 (RH)(ST)
Description
Open and close
• Wear personal means of protection
• Read the user manual before use
Danger of cutting or pinching parts of the body
Manufacturer's information stating: name,
address, CE marking, model indication, serial
number and date of construction, maximum
operating pressure, weight if heavier than 25 kg
916.001.234_004
EN
Part number
920.000.314
920.299.572
920.299.567
920.299.576
21