Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MS171
First allow the machine to cool down before you use it again.
The blade is not suitable for cutting frozen products or bones.
PREVENT OVERLOADING
The appliance will vibrate slightly if it is overloaded. The blade will rotate very slowly
or it will stop rotating altogether. In that case, the best thing to do is switch off the
machine for 15 minutes to allow it to cool down before using it again.
ADJUST SLICING THICKNESS
The slicing thickness can be adjusted from 0-to 15 mm. Turn
the dial (knob) for adjusting thickness (4), to the desired
gauge. The thickness indicator at the top of the slicer shows
the selected thickness.
MAINTENANCE
•
Remove the plug from the power outlet.
•
Never immerse the machine in water.
•
Always clean the slicer immediately after use in order to prevent drying of food
remains.
•
In order to remove food residues rich in oil it may be necessary to use a detergent
and water to clean the machine.
•
Never use a pointed or sharp instrument to remove the remains of food from in
between the blade and machine.
•
The machine cover can be cleansed with a damp cloth.
•
The blade, the support platform, the food carriage, the food pusher and the
foldable tray must be cleaned in water with non-abrasive detergent/soap. Clean
then rinse the parts thoroughly before reassembly.
•
Never use aggressive, abrasive cleansing products or scouring pads to clean the
electrical slicer.
•
Do not put the parts in a dishwasher.
•
The appliance must be completely clean, dry and cooled off before storing it.
www.domo-elektro.be
Publicité
Table des Matières
