Operating - Ferm CDM1124 Traduction De La Notice Originale

Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
pages 2-3
Fig. A
1. Machine
2. Charging socket
3. Charging indication light
4. Bit holder
5. Direction switch
6. On / off switch
7. Work light
8. Charger adaptor
10. Screw driver bit

3. OPERATING

The machine must be charged before
first use.
Charging the machine
• P lug the small cable plug (8A) into the
machine's charging socket (2).
• P lug the charger into an electrical outlet
and wait for a while. The LED indicator on
the machine (3) will lighten up and show the
charging status.
Charging indication light (3)
Fig.A
The machine has a charging indication light
(3) which indicates the status of the charging
process:
LED color Status
Red Battery charging in progress
Red+Green Battery charging finished, battery fully charged
• F ully charging the battery may take up to 3 - 5
hours.
6
Fitting and removing drills or screwdriver bits
Fig. B
The machine bit holder (4) is suitable for drills
and screwdriver bits with a standard ¼ inch.
hexagonal shaft. To fit a screwdriver bit:
• I nsert the screw driver bit (10) into the
machine's bit holder (4), it will be hold by a
magnet.
• T he screw driver bit can be removed by pulling
it out of the bit holder again.
Adjusting the direction of rotation
Fig. A
• S et the direction switch (5) to position '' in
order to drive screws or to use it for drilling.
• S et the direction switch (5) to position '' in
order to remove screws.
Switching the machine on and off
Fig. A
• P ressing the on/off switch (6) will activate the
machine.
• R eleasing the on/off switch (6) will stop the
machine.
• M ove the direction switch (5) to the middle
position to lock the movement of the on/off
switch. It cannot be activated in this position.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for at least 5 seconds to let
the overload protection reset itself.
Spindle lock function
Fig. C
The machine is fitted with an automatic spindle
lock feature. When the on/off switch (6) is not
pressed, the bit holder (4) rotation is locked. Now
it is possible to use the screwdriver (even when
the battery is empty) as a manual tool.