Presentation; Amp - Micromega Minium AMP Notice D'utilisation

Dear Customer,
Thank you for purchasing a Minium product.
Minium is designed as a complete system. Together each component provides ease of use and
sonics of the highest quality. Please pay close attention to this instruction manual, and read it fully
before attempting to operate. It is designed to ensure that you maximise your pleasure of Minium and
familiarise you with its many unique functions
CHECKING
Check that the carton has no damage. Should you have
any doubt about its condition, please do not hesitate to
contact your dealer.
UNPACKING
Very carefully remove the unit from the box, taking care
to preserve all the packing material. It is good practice
to put the carton and its contents into an outer plastic
bag and deposit it somewhere safe and dry. In the
unlikely event that your unit needs to be sent back to
either your dealer or distributor, it must be sent in the
original packing material. Failure to observe this will
invalidate your warranty.
ACCESSORIES
Upon opening the carton, you should find the following
accessories:

AMP

- Mains lead.
CD
- Mains lead.
- Stereo Interconnect pair.
- Remote control handset.
FM
- Mains lead.
- Stereo Interconnect pair.
- Dipole antenna.
MAINS VOLTAGE
• Check that the mains voltage indicated on both the
carton and the rear of the unit correspond to the local
power supply
• If you are in any doubt, consult your dealer
.
INSTALLATION
In order to obtain the maximum performance of
Minium, it is important to follow the installation
instructions
Wherever possible, we recommend that Minium is
installed in an audio rack or other suitable furniture
that provides sufficient ventilation.
By using the top cover indentations on CD and FM, it
is possible to stack the units on top of each other.
If for aesthetic or ease of use reasons, you choose to
stack the units, it is imperative that you place AMP on
the top. Never place any unit on top of AMP. We
recommend that you provide a space of at least 30cm
above AMP in order to ensure adequate ventilation.
CONNECTIONS
Having verified that the mains voltage indicated on the
rear of the unit corresponds to the local power supply
mains voltage, connect the mains leads provided to
the rear of each unit and to the wall sockets.
Connect the Stereo Interconnect cables from the rear
of both CD and FM to the corresponding inputs on
AMP.
Note : You can also connect the digital output of CD
if you wish to utilise an external Digital to Analog
converter.
Connect to the antenna input of FM the dipole
antenna provided or preferably to an external FM
antenna.
Connect your loudspeaker cables between AMP and
your loudspeakers.
Your system is now ready for your listening pleasure.
.
9

PRESENTATION

WARNING!
E