Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.
Screw the 4pcs screws into the plastic expanison bolts.
5.
Mount the appliance on to the screws.
6.
Move the appliance to the right and then down unitl it's secured.
NOTE: The kit supplied in the package is designed for mounting vertically on a solid wall. The heater must be at
least 20 cm removed from all objects, walls, etc.; the distance to the floor must be at least 20 cm and there
must be at least 20 cm above the heater.
OPERATION
Plug the appliance into an appropriate electrical outlet. Power on the appliance by pressing the power switch
to position "I". The power switch will be illuminated. LCD display lights up and shows "OFF". The appliance is
standby. Press the on/off button "
1. Temperature calibration
Long press the button "+" for 5 seconds to enter the temperature calibration, adjusting the number by
pressing button "+" or "-". The calibration ranges from -5 to +5 degrees.
2. Set the temperature.
1) Press the button " + " or " - " to set your desired temperature. You can choose from 0℃ to 37℃.
2) The display will flash the set temperature a few seconds and then turn back to show the current
temperature. It means the temperature has been set.
3) If the set temperature is higher than the current temperature, the appliance will start to heat, and the
" to turn on your appliance.
- 6 -
Publicité
Table des Matières
