Troubleshooting; Cleaning And Maintenance - Kitchenware S250 Premium Manuel D'utilisation

EN SICO KITCHENWARE® NATURAL LABORATORY FOR VACUUM PACKAGE
PROBLEM
Even if the general switch (1) is
placed on position ON, it does not
lighten.
The packer works but it does not
suck air.
When the cycle (suction+sealing)
is finished, air gets into bags
and/or containers.
The sealing bar melts and/or cuts
the bag.
You cannot identify the problem.
Proper maintenance and cleaning are necessary. Firstly, you must unplug vacuum packer. Use mild, non-
abrasive and/or solvent detergents to clean external surfaces. Remove carefully any possible scraps of the bag
from the silicone gasket and the sealing bar. Pay great attention to the cleaning of the upper and lower foam
rubber gaskets and put them back correctly into their place.
7
MANUFACTURER : BISVA SRL TITO PZ ITALIA

TROUBLESHOOTING

SOLUTION
Make sure that the plug is properly inserted in the socket.
Make sure that the cable and/or the plug are not damaged.
Make sure that the plug supplies electric energy.
Make sure that the lid and the gasket of the filter (see the paragraph "
Maintenance of the pump protection filter") are properly placed and
cleaned.
If you are using bags, make sure that they are properly inserted under the
bracket (15) and there are not piercings.
If you are using containers, make sure that the valve and the gasket of
the lids are properly placed and cleaned.
Make sure that lids and containers do not present cracks or holes.
Bags:
•
make sure that they are not pierced.
•
check the sealing because rests and/or wrinkles in the sealing
area could cause the loss of vacuum. In this case, open the
bag and repeat the suction and sealing cycle.
•
When vacuum-packing food with points or protrusions,
remember to wrap it in soft paper napkins and/or silver paper
to prevent protrusions from piercing the bag.
•
Fermentation and/or natural release of gas from the food
vacum-packed could reinflate the bag. Do not eat the food.
Containers:
•
check that the valve and the gaskets are properly placed and
containers and lids do not present cracks or holes.
•
check that the rim of the container is not damaged in the
adherence area of the lid.
Reduce the sealing time.
Do not try to repair the packer by yourselves. Adress the dealer.

CLEANING AND MAINTENANCE

WWW.BISVA.IT INFO@BISVA.IT
EN