Alecto LE-180 Mode D'emploi page 21

4. In the DMX-OUT plug of the last LE-180 device a XLR plug should be inserted. The
terminating resistance should be 120 Ω and be soldered on connection 2 and 3.
Please contact your supplier if needed.
Shielded wired plugs, XLR plugs and termination resistors are not included.
Master-slave configuration:
1. Press the FUNC Button of the first LE-180 device
2. Switch with
3. Press the ENTER Button and select with
4. Press ENTER to confirm
5. Repeat these steps for all LE-180 devices but select at step 3 the status
(SLAVE)
The now all connected LE-180 devices will show synchronously the same light-effect as
selected on the first LE-180 as MASTER.
Managing through the DMX512 controller:
If you have a DMX512 device you need to address every single LE-180 device digitally
to control a certain device. Either you give all devices a single digital address or you
choose to give several devices the same digital address so these devices simultaneous-
ly react on the control signal of the DMX512. The LE-180 device has 2 channels.
1. Press the FUNC Button of the first LE-180 device
2. Switch with
3. Press the ENTER Button, the actual selected address lights-up
4. Select with
Warning: The LE-180 has 2 channels, reserve therefore 2 channels
5. Press ENTER to confirm
Through the DMX512 you have the following light-effects:
Channel: Value:
CH1(*) 0-9
10-49
50-255
CH2(*) 0-9
10-31
32-63
64-95
96-127
128-159
160-191
192-223
224-255
*: Use here the channels as implemented at instruction 4
Through the Alecto website, under 'software' You can dowload a fixture for the LE-180.
or to
or to
or the desired address (
Effect:
No functions
sound controlled
automatic, speed goes from slow to fast
all effects
effect 1
effect 2
effect 3
effect 4
effect 5
effect 6
effect 7
effect 8
or the status
-
21
(MASTER)
)