Alecto LE-180 Mode D'emploi page 20

Operation:
If you connect the mains power supply into the socket plug (100-240V) , the LE-180
activates itself automatically.
The display shows
The LE-180 plays the selected light-effect whereby the speed of the light-effect depends
on the ambient sound. So, the power of the effect depends on the ambient sound , the
harder the noises, the faster the light-effects show.
Effect set-up:
The LE-180 has 8 preselected programs for the light-effects. Effect 0 sequences all
available light-effects.
1. Press the FUNC Button.
2. Switch with
3. Press the ENTER Button, the number of the current light-effect lights up.
4. Select with
5. Press Enter to confirm.
6. The Display stops with flashing and the light-effect starts.
The speed of the light-effect.
You either give a light show with a fixed speed or show a speed that depends on the
ambient sound available. How heavier the ambient sound are how faster the Rhythm of
the light-effects are.
1. Press the FUNC Button.
2. Switch with
3. Press the ENTER Button and select with
detection
4. Press ENTER to confirm
DMX connection:
The LE-180 has a DMX512 plug in and out. With this you can connect several LE-180
devices with each other to show simultaneously the selected light-effect. (Master-Slave).
You also can connect the LE-180 to a DMX512 to set up the preferred light-effect from a
distance.
To connect to a DMX512 controller:
1. Put the cable of the DMX512
controller into the DMX-IN plug
of the first LE-180 device. Only use
shielded cables with XLR plugs.
2. Connect the DMX-OUT plug of the first LE-180 device with the DMX-IN plug of the
next LE-180 device. Use therefore a shielded wire with XLR plugs.
3. Repeat this step until all LE-180 devices are connected.(Max 32)
or shows the previous effect set up or program.
or to
or the goal state (
or to
- )
or to activate or deactivate the sound
To connect as Master-Slave:
Go to step 2
20