Declaration Of Conformity; Disposal Of The Device (Environment) - Alecto LE-180 Mode D'emploi

GENERAL
• Use only indoors. Please, do not use this device in wet or moist environments.
• Do not disassemble this set. This device does not contain any for the user
replaceable parts. Only qualified engineers are allowed to maintain and service this
device.
• Read and follow the manual instructions attentively and completely. Keep this manual
for future reference. In case of resale, give this manual together this device to the
new owner.
• To avoid eye injury, please do not look directly into the LED-light. Sensitive persons
should be aware of the possibility that epileptic attacks could occur.
• Take the power cord from the wall outlet to clean the device and disconnect the DMX
cable (if any). Use a damp cloth to clean the casing.
• Connect the device to wall outlets containing earth connection only. Be sure the cable
remains undamaged and prevent stumbling or falling. This device is only suitable
for power connections shown on the back. Do not use this device behind a dimmer
switch.
• A good heath redundancy is necessary. Do not cover this device. Do not place it close
to another heath source.
• Keep a minimal distance of half a meter, measured from the lens opening where the
light source starts.
• If you want to hang your device, a sturdy construction should be made. Prevent possi-
ble injuries by walking against it or injuries because the device could fall.

DECLARATION OF CONFORMITY

The declaration of conformity is available on the website
WWW.ALECTO.INFO

DISPOSAL OF THE DEVICE (ENVIRONMENT)

At the end of the product lifecycle, you should not throw this product into the nor-
mal household garbage but bring the product to a collection point for the recycling
of electrical and electronic equipments.
18