Installing Coolant Reservoir (Tank) - Makita 9820-2 Manuel D'instruction

Adjusting sharpening holder
The sharpening holder horizontal (forward) adjust
screws should be unscrewed to allow the heel of the
blade to be inserted so as to contact the blade fastening
screws. Then lightly tighten the blade fastening screws
and set the holder on the platform.
1
2
007278
Screw in clockwise the forward adjust screw on the right
until the right upper edge of the blade comes into contact
with the grinding wheel. Then fully tighten the fastening
screw on the far right.
2
007279
Slide the holder to the right across the sharpening
platform guide. Screw in the left-hand forward adjust
screw until the left upper edge of the blade contacts the
grinding wheel. Now use all four fastening screws to
secure the blade on the horizontal.
3
007280
1. Blade fastening
screw
2. Planer blade
3. Forward adjust
screw
3
1. Wheel
1
2. Right-hand
(forward) adjust
4
screw
3. Right-hand
fastening screw
4. Planer blade
3
1. Wheel
1
2. Left-hand
4
fastening screw
3. Left-hand
2
(forward) adjust
screw
4. Planer blade

Installing coolant reservoir (Tank)

Insert the reservoir legs into the grooves provided for
them on the sharpener frame.
1
2
007281
Adjusting coolant flow
Put water in the coolant reservoir. Turn the knob so that
the marking is positioned vertically to make the coolant
flow.
4
007282
Turn the marking to the horizontal position to stop the
coolant flow.
1
4
007283
NOTE:
Adjust the coolant flow adequately. If the debris
•
from the grinding wheel and the blade is washed
away by the coolant, the coolant flow is excessive.
Draining used coolant
The used coolant drains out through the drain hose
(vinyl tube) provided. Have a pan or drain system ready
to catch it.
6
1. Coolant
reservoir (Tank)
2. Grooves
1. Coolant
1
reservoir (Tank)
2. Knob
2
3. Water
4. Marking
3
1. Coolant
reservoir (Tank)
2
2. Knob
3. Water
4. Marking
3