Husqvarna FS 4600 G II Manuel D'utilisation page 20

2. Close the water valve.
3. Connect the water inlet to a water supply.
4. Make sure that the knob for rear axle freewheel
function (A) is disengaged.
A
5. Turn the ignition key to the "I" position (B).
6. Wait 5 seconds and turn the ignition key to the crank
position (C). When the engine starts, immediately
release the ignition key to the "I" position (B).
7. Let the engine operate at idle speed for 2–3 minutes
until the temperature on the display is above 100°F/
40°C.
20
To operate the light kit
The light kit is an option.
1. Install the light kit to the 12 V connector on the
product.
2. Turn the ignition key to the "I" position.
3. Push up the switch for the light kit (A) to make the
light kit come on.
B
C
4. Push down the switch for the light kit (B) to make the
light kit go off.
To operate the water pump
The water pump kit is an option.
1. Install the water pump kit to the product. Refer to the
operator's manual for the water pump kit.
2. Connect the water inlet to a water supply.
CAUTION:
Do not let the engine
operate at idle speed for more than 2–3
minutes when the water cooling system
is off. The gearbox can become too hot
without water supply.
CAUTION:
If the water pump
operates without connect the water to
the product, the water pump can become
damaged.
1657 - 001 - 08.09.2021
A
B