Varan VAR-MIGMMA160 Manuel D'utilisation page 17

MOUNTING THE WELDER
With this multifunction welding unit you can now experience many advantages of the MIG welding and ARC welding
process. The welder's robustness makes it ideal for your weekend DIY all the way up to your Industrial welding
purpose alike. Please read the manual before using.
1. Make sure the welder is earthed before operation.
2. Feeding the wire :
When fitting a new reel adopt the following procedures:
1) Remove the shroud from the torch and unscrew the contact tip, Fit the wire reel onto the spindle. The spring
mounting must be correctly fitted.
The contact tip (A) is consumable items, it is changeable and can also be changed for different size to
suit different wire diameter. To replace it, the torch shroud (B) should be unscrewed. Ensure the wire
get through the contact tip alright and then screw the shroud tightly.
1) Located the free end of the wire usually positioned in a hole on the reel rim. Remove the end
of the wire from the hole and use sharp wire cutters to remove any distorted wire .do not allow the
wire to become slack on the reel
2) Hinge back the pressure arm and feed the end of the wire into the hole in the end of the
liner. Ensure that the wire is fitted so that it is fed into the wire feed mechanism in a straight line
3) Fasten the pressure arm down ensuring that the MIG wire is in the groove in the feed roller.
Ensure that the correct groove is used depending on the diameter of the wire. ig ,one groove is for
0.6mm and the other for 0.8mm
Spool
4) To reverse the roller, unscrew the two screws securing the roller. Supporting bracket and
remove the bracket. The roller can then be removed from it's shaft and reversed
5) Hold the torch straight. Switch the machine on and operate the torch trigger. the wire feed
roller will turn feeding the wire though the torch
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
Solid wire Flux cord wire
T: 00352/26908036 – F: 00352/26908040
VAR-MIGMMA160
VAR-MIGMMA200