Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Before use, read manual and labels
WARNING
of the power head. Important as-
sembly and use instructions are provided in the
power head manual. Connect the attachment to
the power head in accordance with the power
head manual.
Do not operate the tool without the guard in place.
The guard must be attached properly during use.
Operating the tool without the guard will cause
serious injury.
Always remove battery pack before changing or
removing accessories.
Replacing the Blade
Always inspect blades before use and replace if
worn or damaged.
1. Remove the battery pack.
2. Turn the gear head on its side and rotate the
blade until the slots align. Slide the holding pin
through the slots.
Flange
Slots
Holding pin
3. Use a 13 mm wrench or socket to loosen the blade
nut (clockwise).
4. Remove the blade nut, flange, and blade.
5. Clean any debris from the flange, nut, and spindle.
6. Place the new blade flat on the spindle.
7. Place the flange and nut on the spindle. Tighten
securely with a 13 mm wrench or socket (coun-
terclockwise).
NOTE: Always make sure blade is undamaged,
correctly installed, and securely fastened before
each use.
Blade
Blade nut
Adjusting Depth of Cut
1. Remove the battery
pack.
2. Loosen the height
adjusting knob and
slide the wheel up to
increase the depth,
or down to decrease
the depth.
3. Tighten the height
adjusting knob se-
curely.
NOTE: Start the job with a shallow blade depth (1/2"
to 1") and increase depth by 1/2" until the desired
cut is achieved.
Selecting the Speed
When using this attachment, only HIGH
SPEED is recommended. Use the speed
control button to select HIGH SPEED.
5
Increase
Decrease
Adjustment knob
High
Low
Publicité
Table des Matières
