Summer Infant 12361 Mode D'emploi page 2

Double barrière de lit
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 4
ASSEMBLY & USE:
MONTAGE ET UTILISATION :
ENG
FR
MONTAGEM E UTILIZAÇÃO:
MONTAGGIO E UTILIZZO:
PT
IT
MONTAGE UND VERWENDUNG:
СБОРКА И ИСПОЛЬЗОВАНИЕ:
DE
RU
A
B
D
E
G
H
J
K
L
M
N
ENSAMBLAJE Y USO:
COMPONENTS:
ENG
ES
MONTAGE EN GEBRUIK:
NL
MONTAŻ I OBSŁUGA:
PL
:‫ﺍﻟﺗﺟﻣﻳﻊ ﻭﺍﻻﺳﺗﺧﺩﺍﻡ‬
AR
Straight tubes labelled 'A' x6
C
Leg supports x4
ASSEMBLY:
F
I
Panel Assembly (refer to the diagram for the location of the various parts):
Step 1: Join all tubes labelled 'A' together. Press down the spring tab and push the tubes together, making sure the tab pops up in the hole (Figures A & B).
Step 2: Repeat for tubes labelled 'B'.
Step 3: Connect tubes 'C' together and then add tubes 'D' to the other ends of the curved sections.
Step 4: Lay the fabric panel on a flat surface. Insert curved tube assembly ('C' and 'D') through the channel in the upper part of the fabric panel
(Figure C and D).
Step 5: Insert tube assemblies 'A' and 'B' into the loops in the fabric panel (Figure E).
Step 6: Find the left hand hinge (labelled 'L'). Make sure it looks exactly like the picture (Figure F). If necessary, press the release button and rotate
the parts until correctly positioned.
Step 7: Fit the ends of tubes 'A' and 'B' into the corresponding sockets in the left hand hinge (Figure G).
Step 8: Rotate the entire hinge moulding and at the same time, insert the end of the curved tube assembly (Figures H, I).
Step 9: Fit the other hinge to the opposite ends of the tubes. Insert tubes A and B first followed by the end of the curved tube. Repeat for
second panel.
Step 10: Secure the fabric tabs at each end of the bedrail panel using the hook/loop fastening, making sure each one wraps around the leg of the
hinge moulding as shown (Figure O).
Leg Assembly:
Step 1: The leg components are labelled A1 and A2. Use all A1 components to make one leg and all A2 components to make the other.
Step 2: Fit the plastic leg supports to the four curved legs. (Figure J).
Step 3: Fit the middle sections of the legs.
Note: The middle section has a number of holes to allow the leg to be adjusted to fit various mattress sizes (Figure K).
O
Step 4: Lay one bedrail side flat on the floor and attach the legs to the hinge mouldings. Lay the other side flat on the floor and fit the other end
of the legs to the hinge mouldings. Note that the pins on the legs must engage with the holes in the mouldings. (Figures L & M).
Straight tubes labelled 'B' x6
Straight tubes labelled 'D' x4
Curved tubes x4
Straight tube labelled 'C' x2
Hinges L x2 & R x2
Legs x2
Fabric panel x2
L = Left, R = Right
C
C
C
C
D
D
D
D
A
A
A
A
B
B
B
B

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1237112471

Table des Matières