Procedures In Case Of Defects - VTS VOLCANO VR Mini Manuel D'installation, D'utilisation Et D'entretien

VOLCANO VR Mini
VOLCANO VR1
VOLCANO VR2
VOLCANO VR3
VOLCANO VR-D
9. SERVICING

9.1 PROCEDURES IN CASE OF DEFECTS

Problem
Heat exchanger leaking
EN
Damaged casing
ARW – rotation controller
Actuator does not open
the valve
Programmable thermostat
does not send any signals
to the actuator/ controls
the operation of the
Check points
safeguards against internal twisting of the collectors,
exchanger,
permitted values,
has been drained) and outside temperature at the time of failure (risk that the
exchanger may freeze),
ammonia in the air in a sewage-treatment plant),
maintenance manual (e.g. distance from wall/ceiling),
characteristics of the device, if there outlet air chokes),
manual) – U1 – TK (TB),
engine,
comparison to wires clamped in the engine terminal strip,
in electric clamps, cross-section and the material wires are made of) and
over),
over),
(permitted only if contactor is used!),
www.vtsgroup.com,
VR Mini, VR1, VR2, VR3, VR-D
40
Description
Pay special attention that the exchanger may freeze during winter
pressure tests. The defect can be removed by pulling back vent or
drain valve.
min. 40 cm
Level of operating noise of VOLCANO devices is perceived
subjectively. If the device is made of plastic, it should operate
quietly.It is recommended to unscrew the clamping screws and
tightening them up again. If the fault does not disappear, you should
make a complaint.
drawings in the manual. If there is no bridge between U1 and
TK(TB) clamps, the motor lacks thermal protection and may break
– burn.
It is recommended to check the device/ speed controller by
connecting the heater directly to power supply.
If the casing is damaged, make photos of the box and device, and
and on the box are the same. If the device was damaged during
transport, it is necessary to write down an appropriate statement by
the driver, who delivered the damaged device.
checked:
working conductors
The most important is to check whether the actuator responded
to the electric impulse within 11s. If the motor is damaged, you
need to make a complain and switch actuator operation to manual
(MAN), which mechanically opens the valve.
(every 2 years). Also, the sensor needs to be periodically calibrated
– detailed information can be found on: www.vtsgroup.com
connected to the motor, without a contactor. If the sensor incorrectly
measures the temperature, it should be calibrated (instructions in
the catalogue).