Transmitter; Battery Charging - XciteRC Rocket 400 GPS Mode D'emploi

Transmitter · Battery charging
Battery compartment-
cover
1
• Close the battery compartment cover, then turn on transmitter – push ON / OFF switch.
• The red POWER LED must lit.
model may not started – crash hazard! Change transmitter batteries immediately.
WARNING: check the POWER LED also during operation. If the POWER LED starts to blink, stop
•
operation, switch the model off and replace the transmitter batteries – crash hazard!
• ATTENTION: The maximum range of the remote control system is about 600 meters. This model
is equipped with an Coming Home function and comes automatically back to the starting point after
exceeding the maximum range. This works only if a sufficient GPS signal was present at the start - read
the section LEDs and their meaning.

Transmitter

Auxiliary channel 1
Manual Mode Indicator Light
SWB Mode switch
Throttle, Turning Left/Right Stick
Trimmer
Power ON/OFF
Buzzer speaker

Battery charging

WARNING: Be sure to read all safety instructions regarding the use of rechargeable batteries. Charging
may take place only with the supplied charger on a fireproof surface and under constant adult supervision -
fire or explosion hazard!
• Connect the power supply with the charger. The green LED lights up.
• Connect the batteries balancer wire with the charger.
WARNING: The balancer connector is polarized. Check the side channels. Do not use force - fire
•
or explosion hazard!
XciteRC Rocket 400 GPS
4x 1.5 V AA
2
batteries
Attention: if the POWER LED flashes or does not light at all, the
2.4GHz Antenna
Auxiliary channel 2
SWA Mode switch
0 0
+ +
Stable Mode Indicator Light
One key To Return Home Mode
Forward/Backward
Left side/Right side flying stick
Power indicator light
Low voltage indicator light
EN
19