Checklist For Malfunctions And Problems; Warranty - REMA CSH Série Mode D'emploi

10 CHECKLIST FOR MALFUNCTIONS AND PROBLEMS

Failure/malfunction
Fastening hinge is too
stiff
Housing bent
Fastening is oval
Spindle turns stiffy
Spindle bent
Split pin missing
Clamp opens/closes
stiffly

11. WARRANTY

REMA HOLLAND B.V. provides a 5 year warranty on its lifting clamps. This warranty is applicable to
the original end user of the lifting clamps. Only if the clamp has been inspected, checked and
maintained by this instructions and by an official dealer. This warranty period of 5 years is valid
from the day of purchase, and is liable to all conditions and measurements stated in this
document.
11a CONDITIONS
The warranty only covers defects in the hoisting equipment resulting from manufacturing
errors arising during normal use. The warranty does not cover wear to components such as
pivots, cams, tensioning springs, etc. If a defect occurs within this warranty period, the lifting
equipment will be replaced or repaired as the producer thinks fit.
No warranty is given for clamps in which defects occur due to:
- Regular wear and tear.
- Overloading.
- Incorrect and/or rough use.
- Damage.
- Non-compliance with procedures and measures.
- Lifting materials other than those shown on the clamp or in the user manual.
- Modification/adaptation of the REMA clamp.
- Improper use of the clamp, and non-compliance with any instructions given in the user manual
in question.
- Maintenance and/or revision work not being carried out by an authorised REMA dealer.
The manufacturer cannot be held responsible for incidental damage or damage resulting
from use of the lifting equipment or from violation of these warranty terms.
Possible Cause Action
Clamp overloaded Reject clamp
Clamp overloaded
Reject clamp
Clamp overloaded
Reject clamp
Clamp overloaded
Reject clamp
Clamp overloaded Reject clamp
Incorrect
Fit in a new split pin
installation
Clamp overloaded Reject clamp
14