Magnat WSB 50 PRO Mode D'emploi & Garantie page 11

SETTING UP THE SYSTEM COMPONENTS
Soundbar (A): The soundbar should be positioned directly underneath the centre of the TV. If the TV is located
on a shelf or sideboard, the soundbar can be positioned directly in front of the device. If the TV is mounted on
the wall, the soundbar should be mounted directly below the screen by using the supplied wall bracket.
Subwoofer (B): The subwoofer should be positioned on the floor near the Soundbar, usually to the left or
right-hand side of the TV. The distance to the screen should not be less than 100 cm for CRT TVs and 50 cm
for flat screen TVs.
Use of the supplied wall bracket for the soundbar is illustrated in Fig.1.
Important information / safety instructions: The customer is solely responsible for the use of other wall
brackets / attachments. The customer is also solely responsible for the secure attachment of the Soundbar
bracket to the wall and the selection of suitable mounting material (e.g. screws, wall plugs, etc.), while taking
account of the weight and construction of the Soundbar and the condition of the wall.
SYSTEM INSTALLATION (ABB. 2 AND 5)
Connecting a TV to audio input INPUT 1:
Use the supplied audio cable (G) and connect the audio output on your TV to audio input INPUT 1 (4). If your
TV has an audio output with fixed level, this is preferable to the audio output with variable level.
If your TV is equipped with a 3.5 mm audio output jack (e.g. headphone socket), you can use the supplied
adapter (F).
Connecting an additional analogue audio source to INPUT 2:
An additional audio source (e.g. MP3 player, CD player, etc.) can be connected to audio input INPUT 2 (5).
The necessary connecting cable is not included in delivery.
Connecting a digital audio source to the DIGITAL input (WSB 50 PRO only):
Use the supplied optical cable (H) and connect the digital audio output of the device to the audio input D (3) of
the soundbar. Dolby Digital-encoded signals can also be reproduced via the built-in Dolby decoder.
Connecting the power supply of the soundbar:
Included in delivery are a universal, external mains adapter (C) (110 - 240 V / AC 50/60 Hz) and the most
commonly used mains cable (I). The mains cable used in your country, however, may be different. If the mains
cable is not compatible with your power sockets or if you are in any doubt, please contact your Magnat dealer.
1. Connect the output cable (jack connector) of the small external mains adapter to the power supply jack of
the Soundbar (2).
2. Insert the 2-pin mains cable into the jack on the mains adapter.
3. Insert the mains cable into the socket. Make sure that you are using the mains plug that is compatible with
the socket (refer to the information above).
Mains connection of the subwoofer:
Connect the power connector of the subwoofer (23) to an electrical socket via the mains cable (I).
GB
11