Ibiza Light PLUTON10-LZR Manuel D'utilisation page 5

StGE Stage
Tv TV
ArAL Architectural
tHAL Theatrical
SLnd
This option is for setting the unit's Master-slave mode. Press MENU to select SLnd Then press Enter to start setting.
You will find MAST, SL1, SL2. Press UP or DOWN to choose Master or slave, then press Enter again to confirm your
selection.
MAST: Choose the device as master
SL1: Choose the device as slave
SL2: Assistant Mode
AUTO program (sound active mode)
1. Press the MENU button until "AUTO" is displayed, press ENTER.
2. The Display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" or "OFF".
3. If you choose "OFF", the unit will be in sound controlled mode and you can set the sound sensitivity.
Sound sensitivity
1. Press the MENU button until "SENS" is displayed, press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound sensitivity. 0 being
the least sensitive and 100 being the most sensitive. When you have found your desired setting press ENTER to
confirm.
Pan Inversion
1. Press the MENU button until "PINT" is displayed, press ENTER. Either "YES" or "NO" will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm. To
deactivate Tilt inversion, select NO and press Enter.
Tilt Inversion
1. Press the MENU button until "TILT" is displayed, press ENTER. Either "YES" or "NO" will be displayed.
2. To activate the Tilt inversion press the UP or DOWN buttons until YES is displayed, press ENTER to confirm. To
deactivate Tilt inversion, select NO and press Enter.
Display back light
1. Press the MENU button until "LED" is displayed, press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to keep the LED display
on at all times, or "OFF" to switch to have the LED display switch off after 10 seconds.
3. Press ENTER and then press and hold the MENU button for at least three seconds to confirm.
Display Reverse 180°
1. Press the either the MENU button until "DISP" is displayed, press ENTER.
2. Press the UP button to select "DSIP" to reverse the display, or "DISP" to change the display back.
3. Press ENTER to confirm.
Self test program
1. Press the MENU button until "TEST" is displayed, press ENTER.
©Copyright LOTRONIC 2017 PLUTON10-LZR Page 5