Rear Spacers - Electrolux EN3601AOX Notice D'utilisation

8.2 Location
A

8.3 Rear spacers

4
8.4 Levelling
B
2
1
3
The appliance should be installed well
away from sources of heat such as ra-
diators, boilers, direct sunlight etc. En-
sure that air can circulate freely around
the back of the cabinet. To ensure best
performance, if the appliance is posi-
tioned below an overhanging wall unit,
the minimum distance between the top
of the cabinet and the wall unit must be
at least 100 mm . Ideally, however, the
appliance should not be positioned be-
low overhanging wall units. Accurate
levelling is ensured by one or more ad-
justable feet at the base of the cabinet.
WARNING!
It must be possible to discon-
nect the appliance from the
mains power supply; the plug
must therefore be easily acces-
sible after installation.
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
2. Engage the spacer below the
screw.
3. Turn the spacer to the right posi-
tion.
4. Tighten again the screws.
When placing the appliance ensure that
it stands level. This can be achieved by
two adjustable feet at the bottom in
front.
ENGLISH 39