Electrical Connection; Door Reversibility - Electrolux EN3601AOX Notice D'utilisation

40 www.electrolux.com

8.5 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic
power supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not

8.6 Door reversibility

A
B
E
F
C D
earthed, connect the appliance to a
separate earth in compliance with cur-
rent regulations, consulting a qualified
electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
WARNING!
Before carrying out any opera-
tions, remove the plug from the
power socket.
To carry out the following opera-
tions, we suggest that this be
made with another person that
will keep a firm hold on the
doors of the appliance during
the operations.
To change the opening direction of the
door, do these steps:
• Open the doors. Unscrew the middle
hinge (B). Remove the plastic spacer
(A)
• Remove the spacer (F) and move to
the other side of the hinge pivot (E).
• Remove the doors.
• Remove the left-hand cover pin of
the middle hinge (C, D) and move to
the other side.
• Fit the pin of the middle hinge (E) into
the left-hand hole of the lower door.
• Unscrew the upper hinge pivot and
screw it on the opposite side.