Rear Spacers - Electrolux ERF3869SOW Notice D'utilisation

3
4. Remove the transport support (4)
from underneath the water unit.
5. Cut the pump securing tie (5) and
remove it.
CAUTION!
Some models are fitted with
a silencing pad under the
cabinet. Do not remove this
pad.

8.5 Rear spacers

Install the two spacers and the locking
pins provided within the accessory bag
as shown in the figure.
2
5
4
8.6 Connecting the water hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5 m
from the appliance.
This work is to be carried out by a skilled
plumber.
There are different type-approved taps
and tap assemblies on the market.
The water hose must not be cracked,
squeezed or put in tight bends.
The safety valve provided in a package
inside the appliance should be used to
prevent overflow. Before the safety valve
is placed on the tap, turn the pointer
clockwise to number 10 with the
enclosed plastic key. Install the safety
valve on the tap and let at least 10 litres
of water flow through the device. Before
connecting the appliance turn the pointer
to number 1 on the safety valve. If the
safety valve has shut off, detach it and
press the red plunger which is located
inside the lower housing of the device
itself.
Before the appliance is placed its final
location, ensure that the water
connection has been correctly carried
out, that there is no leakage at the
connection to the water tap.
Tighten the screw enough by hand.
Make sure that the gasket is properly
positioned in the connector.
We recommend that the appliance is
placed on a "run-off" mat intended for
refrigerators and freezers, which makes it
easier to detect possible leakage
ENGLISH 39