Pairing A Bluetooth Device; Bluetooth Mode - Denon Professional Envoi Go Guide D'utilisation

Operation

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Envoi Go.
3. Press and release the Mode button to enter Bluetooth Mode.
Navigate to your Bluetooth device's setup screen, select Envoi Go, and connect.
4.
Note: If prompted for a passcode, enter 0000.
5. Play music from your Bluetooth device.
6. Adjust the volume from Envoi Go by holding down the |<< or >>| button to decrease or increase the
volume.
7. To disconnect pairing, turn off Bluetooth on your device or select "Delete paired info" from the Envoi Go
Bluetooth menu.

Bluetooth Mode

To access a paired Bluetooth device:
1. Press and release the Mode button until the Bluetooth icon appears on the screen. The previously
paired device will then connect automatically.
Note: When you connect a USB device, SD card, or Bluetooth device, Envoi Go will automatically
switch to the most recently connected source.
2. In Bluetooth mode, press and hold the Mode button for 2 seconds to see additional options.
Use the |<< and >>| buttons to scroll through and press Play/Pause to select one of the settings seen
3.
below.
BT Disconnect: This function disables the connection from the Bluetooth audio source.
EQ: Envoi Go provides 7 optional equalizer presets to enhance music. You may select from these EQ
settings:
• Normal (Nor)
• Pop
• Rock
• Jazz
• Classic (Clas)
• Country (Cou)
• Low Bass (Bas)
Note: The digital EQ presets can only be applied to Bluetooth, SD, and USB sources.
Delete Paired Info: Select this to "forget" a previously paired Bluetooth device so that Envoi Go will not re-
connect when switching back to Bluetooth mode.
Device Information: Shows Envoi Go's device name.
Exit: Leaves the Bluetooth menu.
10