Audiovox DAB+ 100 DAB-Box Mode D'emploi page 19

The aerial must be mount in such a manner that it does not impair vision when driving.
The aerial should preferably be mounted on the windscreen from the inside.
Due to the polarisation of the DAB transmission signal, the aerial must be mounted vertical to the
ground.
The distance to other aerials must be more than 80 mm. On vehicles with windscreen heater, take
care that the aerial is not mounted on top of the heating wires.
Before applying the aerial, the windscreen must be clean, dry and free of grease. If necessary,
clean the windscreen and remove all cleaning agent in order to ensure for a safe adhesion of the
aerial adhesive tape.
In event of low temperatures, the windscreen should be warmed-up using the vehicle heater to
allow the aerial adhesive tape to bond safely. The aerial is only intended for being installed once
(sticking on). Please do not remove the aerial and remount it. The adhesive tape will be damaged
when removed.
Determine the installation location of the aerial according to the instructions above.
Remove the white protective film on the back side of the black aerial housing that conceals the
adhesive tape for the aerial housing.
Peel back the yellow protective film of the thin aerial wire by approx. 2 cm on each side of
the adhesive tape. Take care that you do not break the thin aerial lines. Using adhesive tape,
temporarily fix the black aerial housing onto the windscreen and press it onto the black housing.
Hold the aerial line and peel off the remaining yellow protection film little by little and in doing so,
press the adhesive film tight to the windscreen. Press on the black aerial housing again. Make
sure that it is secured tightly on the windscreen.
Now route the aerial cable to the DAB tuner and screw in the aerial tight.
19