Abicor Binzel ALPHA FLUX Mode D'emploi page 27

ALPHA FLUX
9.3.1 Replacing the neck liner
 Fig. 2 Mounting the torch neck liner on page EN-7
1 Unscrew the clamping screw at the handle, remove the torch neck (1) and pull out the old
torch neck liner (3).
2 Insert the new neck liner from the rear into the torch neck (1) up to the stop and measure the
length.
3 Shorten the torch neck liner at the front side until the inlet nipple (2) terminates flush at the
torch neck (1) and debur the edge.
4 Slide the torch neck (1) into the handle as far as it will go and secure it with the clamping
screw.
9.3.2 Shortening the spiral liner
 Fig. 3 Mounting the liner on page EN-8
NOTICE
• New still unused liners have to be shortened to the actual length of the cable assembly.
1 Lay down the cable assembly straight.
2 Unscrew retaining sleeve (6) / clamping bolt (7).
3 Insert the new liner (5).
4 Measure the excess length of the liner:
• subtract 15 mm in case of a central connection
• add 1 mm in case of a Lincoln connection
5 Pull out liner (5).
6 Shorten the front side of the liner by the calculated length
7 Debur the edge
8 Insert the liner (5).
9 Tighten retaining sleeve (6) / clamping bolt (7).
10 Disposal
NOTICE
• Do not dispose of the device with household waste.
• For disposal, observe the local regulations, laws, provisions, standards and guidelines.
BAL.0153 • 2018-08-24
10 Disposal
EN - 13