ALPHA FLUX
Equip the torch neck according to one of the following figures:
1
1
Contact tip
2
Insulator
Fig. 1
Equipping the torch
1not for wire
2.4
1 Screw set screw (3), sleeve (4) and ceramic sleeve (5) to a length of 10.5 mm into the torch
neck (6) by means of an Allen wrench AF 4.
2 Screw contact tip (1) firmly into torch neck.
3 Screw insulator (2) onto torch neck (6) by hand.
6.2 Mounting the torch neck liner
1
Torch neck
Fig. 2
Mounting the torch neck liner
1 Unscrew the clamping screw at the handle and pull out the neck liner (1)
2 Insert the torch neck liner (3) from the rear into the torch neck (1) up to the stop and measure
the length.
3 Shorten the torch neck liner (3) at the front side until the inlet nipple (2) terminates flush at
the torch neck (1) and debur the edge.
4 Slide the torch neck (1) into the handle and secure it with the clamping screw.
BAL.0153 • 2018-08-24
2
3
Set screw
4
Sleeve
1
2
Inlet nipple
3
4
5
10.5 mm
5
6
3
6 Putting into operation
6
1
Ceramic sleeve
Torch neck
2
3
torch neck liner
EN - 7