Exchange Of Saw Blade - holzkraft HWS 720 K Traduction Des Instructions D'origine

20. Exchange of saw blade

Wait until stationary and allow to cool down. Remove the mains plug or remove the spark plug connector!
• The exchange of the saw blade can only be undertaken in firewood cut
position.
• Loosen the top and bottom screws on the protective cover approx. 5 mm
and open the protective cover.
• To lock the saw blade into place, insert the locking pin (1) through the cor-
responding opening on the saw blade guard. To do this, insert the pin com-
pletely and straight into the hole. Use the corresponding hole (depending
on the saw blade type) so that the pin is at the lowest point (bottom of the
tooth).
• Loosen the saw blade with the supplied open-end spanner / Allen wrench
(2).
• Remove the saw blade flange
• Insert the new saw blade.
• Mount the saw blade flange again and tighten the clamp screw.
• Remove the locking pin.
m Attention! When installing the saw blade, pay attention to the
correct direction of rotation!
GB
2
1
page: 31