Starting The Engine; End Of Work - holzkraft HWS 720 K Traduction Des Instructions D'origine

Starting the engine

Follow the procedures below for a cold start:
• Open the fuel valve (B) to the right in the opening
position.
• Turn the choke lever (A) on the engine fully to the
left, to the "ON" position.
• Move the throttle lever (C) on a semi-open position.
• Turn the ignition switch (E) to ON.
• Pull slowly several times the reverse starter handle
(D) so that the fuel flows into the carburettor. Then
hold the reverse starter handle (D) and pull the ca-
ble out slightly until you feel resistance. Then pull
the cable in a quick motion and let the cable rewind
slowly again. Do not allow the cable to snap back.
Tighten if necessary, the reverse starter handle (D)
repeatedly until the engine starts.
• Let the engine warm up for a few seconds. Then
gradually move the choke lever (A) to the right in the
„OPEN" position.
The restart of an engine that is already hot from the previous operation usually does not require use of the choke.
1. Open the fuel valve (B) to the right in the opening position.
2. Move the throttle lever (C) on a semi-open position.
3. Turn the ignition switch (E) to ON.
4. Then hold the reverse starter handle (D) and pull the cable out slightly until you feel resistance. Then pull the reverse starter han-
dle (D) in one swift movement and leave the cable to wrap back slowly. Do not allow the reverse starter handle (D) to snap back.
After the engine starts, move the throttle lever (C) to full throttle position, so that the splitter can achieve its maximum working force.

End of work

• Set the throttle (C) at the slow position to the stop position.
• Close the fuel shut-off valve (B).
• Observe general maintenance instructions.
• Place the jack in the transport position and secure it with the locking lever.
The HS720/HS720B provides maximum safety thanks to its enclosed sawing area.
Prior to commissioning the device for the first time:
Cut off the cable ties on the tension springs. Open the protective cover (1) and mount the tension springs as displayed in the image.
GB
A
B
D
C
page: 27
E