Introduction; General Instructions; Safety Instructions - holzkraft HWS 720 K Traduction Des Instructions D'origine

1. Introduction

Manufacturer:
Stürmer Maschinen GmbH
Dr.-Robert-Pfleger Straße 26
96103 Hallstadt
0049 (0) 951 96555 - 55

info@holzkraft.de

www.holzkraft.de

Dear client,
We hope you enjoy your new firewood circular saw and wish you success with it.
INFORMATION:
The manufacturer of this tool is, according to the current product liability law, not liable for damages caused to or by this tool because
of:
• incorrect usage,
• failure to observe the manual,
• repairs by third parties, not authorized specialists,
• fitting and exchange of non-original exchange parts,
• non-intended use,
• falling out of the electrical installations because of inobservance of the electrical Rules and VDE-Regulations 0100, DIN 57113 / VDE0113.
We recommend that you:
Read the entire operating instructions before assembling and implementing.
This instruction manual should make it easier for you to get to know your machine and to use its range of applications as intended.
The manual contains important information on how to work with the machine in a secure, correct and efficient way, and how you can
avoid risks, save repair costs, reduce down time and increase the reliability and life span of the machine.
Apart from the safety rules mentioned in these operating instructions, you should implicitly pay attention to the valid regulations of
your country for the use of the machine.
Keep the manual, in a plastic cover protected against dirt and humidity, with the machine. They should be read and observed care-
fully by every member of staff before starting to work. Only people instructed on how to use the machine and informed about the
possible risks, should be allowed to use it. The required minimum age is to be adhered to.
Besides the safety instructions in this manual and the special regulations of your country the recognized technical rules for the op-
eration of wood processing machines need to be observed.

General instructions

• After unpacking please check all parts for possible damage during transport. In case of complaints the driver needs to be con-
tacted as soon as possible.
• Complaints coming in later will not be recognized as such.
• Familiarize yourself with the machine by means of the operating instructions before implementing it.
• In case of replacing worn or exchange parts, as for accessories, only use original parts. You can obtain exchange parts at the
specialized dealer.
• Upon ordering, please specify our article no´s as well as type and year of construction of the tool.
2. m Safety instructions
• In these operation instructions we have indicated positions that concern your safety, with this mark: m
• Take due note of all this information before and while working with the saw.
• Do not lose these safety regulations.
• When equipment is not being used it should be kept in a dry, closed place out of childrens reach.
• Keep mounted attachments sharp and clean to enable you to work well and safely.
• Pay attention to - What you do. Always work in accordance with the regulations. Do not use the tool when you are tired.
• Do not use tools that do not allow to turned on and off the switch.
• Warning! The use of other tools and accessories may put you at risk of injury.
• Warning: Always unplug the power plug or remove the spark plug connector prior to starting any of the maintenance work de-
scribed in this manual.
• Give these safety regulations to all persons who work on the machine.
• Caution! Hands and fingers may be injured on the rotating saw blade.
• Do not leave the saw in the rain and never use it in damp or wet conditions.
• Provide good lighting.
GB
page: 19