BluMill OL-BKY26-A011F Mode D'emploi page 9

TROUBLESHOOTING
EN
Symptom Inspection
The unit is not operating. Check the power
connection in securely.
Check if the water level
indicator lights up?
Check the room
temperature.
The unit works with Check the air filter for dirt.
reduced capacity.
Check if the air duct is
blocked.
Check if the room door or
window is open.
Check if the desired
operating mode is selected
and the temperature is
properly set.
The exhaust hose is
detached.
Water Leakage Overflow while moving the
unit.
Check if the drain hose is
kinked or bends.
Excessive Noise Check if the unit is securely
positioned.
Check if any loose, vibrating
parts.
Noise sounds like water
flowing.
16
Solution
Insert the power cord
securely into the wallOutlet.
Empty the drain pan by
remove the rubber plug.
The range of operating
temperature is 5-35ºC.
Clean the air filter as
necessary.
To clear the obstacle.
Keep the door and windows
closed.
Set the mode and
temperature at proper
set-point according the
manual.
Make sure the exhaust
hose is securely attached.
Empty the water tank
before transport.
Straighten the hose to
avoid a trap existing.
Place the unit on horizontal
and firm ground.
Secure and tight the parts.
Noise comes from flowing
refrigerant. This is normal.
Symptom Inspection
Error E0 Communication faults
Codes between main PCB and
display PCB.
E1 Ambient temperature sen-
sor failure
E2 Coil temperature sensor
failures.
Ft Condensate water high
level alarm.
8. DECOMMISSIONING
STORAGE
Long-Term Storage - If you will not be using the unit for an extended period of time (more
than a few weeks) it is best to clean the unit and dry it out completely. Please store the
unit per the following steps:
1. Unplug the unit and remove exhaust hose and window kit store with the unit.
2. Drain the remaining water from the unit.
3. Clean the filter and let the filter dry completely in a shaded area.
4. Re-install the filter at its position.
5. The unit must be kept in upright position when in storage.
6. Preserving the machine in ventilating, dry, non- corrosive gas and safe place indoor.
ATTENTION:
The evaporator inside the machine has to be dried out before the unit is packed to avoid
component damage and molds. Unplug the unit and place it in a dry open area for days to
dry it out. Another way to dry the unit is turn on the machine, adjust it to low-wind ventila-
tion mode, and maintain this state until the drainage pipe becomes dry, so as to keep the
inside of the body in a dry state and prevent it from mildewing.
WARNING!
Releasing refrigerant into atmosphere is strictly forbidden!
Solution
EN
Check the wire harness
of the display PCB for
damage.
Check connection or re-
place it. To clean or replace
the temperature sensor.
Check connection or re-
place it. To clean or replace
the temperature sensor.
Empty the drain pan by
removal the rubber plug.
17