Attach The Exhaust Hose; Choose Your Location - BluMill OL-BKY26-A011F Mode D'emploi

UNPACKING
EN
•
Unpack the carton and take the appliance and accessories out.
•
Check the device after unpacking for any damage or scratches on it.
•
Accessories:
1. Exhaust hose
2. Hose connector
3. Window kit adapter
4. Remote control
5. Window kit
1 2

Choose your location

•
If tipped more than 45°, allow the unit to set upright for at least 24 hours before start
up.
•
Place the unit on a firm, level surface in an area with at least 50cm of free space
around it to allow for proper air circulation.
•
Do not operate in close proximity to walls, curtains, or other objects that may block
air inlet and outlet. Keep the air inlet and outlet free of obstacles.
•
Never install the unit where it could be subject to
•
Heat sources such as radiators, heat registers, stoves or other products that pro-
ducts that produce heat.
•
Direct sunlight
•
Mechanical vibration or shock
•
Excessive dust
•
Lack of ventilation, such as cabinet or bookcase
•
Uneven surface
WARNING!
Install the unit in rooms which exceed 10 m².
Do not install the unit in a place where inflammable gas may leak.
8
3 4 5

ATTACH THE EXHAUST HOSE

The air conditioner requires being vented outside so that the exhaust air can escape the
room which coming from the appliance contains waste heat and moisture.
Do not replace or extend exhaust hose which will result in decreased efficiency, even
worse shut down the unit due to low backpressure.
Connect the hose connector to one
end of the exhaust hose.
Extend the adjustable window kit the
length of your window. Connect the
exhaust hose to the window kit.
Attach the hose connector to the
exhaust air outlet of unit.
Connect the windows kit adapter to
the other end of the exhaust hose.
Close your window to secure the kit
in place. It needs to hold the win-
dows kit firmly in place, secure the
window kit with duct tape if required.
It is recommended that the gap
between the adapter and the sides of
the window should be sealed off for
maximum efficiency.
Adjusting the length of the flexible
exhaust hose, and avoid bends in
the hose. Then place AC near an
electrical outlet.
Adjust the louver at the air outlet, and
then switch on the unit.
EN
9